Rotex Handpiece Repair

Our Pledge to you
Thorough Testing Of Your Rotex Handpiece. All Rotex handpieces are thoroughly tested before any repairs begin. We test your Rotex handpiece for: torque, water leaks, clogged water lines, and excessive noise or vibration, as well as stripped metal chucks.

Rotex Handpiece Repairs Are Never Done Unnecessarily. If a Rotex handpiece is sent to us for repair and needs only a chuck, this will be all we repair and advise you that that Rotex handpiece did not need a complete overhaul. If a Rotex handpiece is tested and found to run and cut well, and does not require further repairs, we will not repair it arbitrarily, but rather advise you to check your unit or air pressure source or other give other advise.

Same Day Service For Your Rotex Handpiece Repair. Most Rotex handpiece repairs are done the same day that we receive them, and we ship your Rotex handpiece repaired the following business day. Should there be any necessary delay, we will immediately notify you of the situation of your Rotex handpiece repair.

Quality Parts In Our Rotex Handpiece Repair. We use only the very best quality bearings and parts for W&H Adec handpiece repairs. We absolutely never use inferior quality or surplus bearings in any Rotex handpiece repairs.