Upower Handpiece Repair

Our Pledge to you
Thorough Testing Of Your Upower Handpiece. All Upower handpieces are thoroughly tested before any repairs begin. We test your Upower handpiece for: torque, water leaks, clogged water lines, and excessive noise or vibration, as well as stripped metal chucks.

Upower Handpiece Repairs Are Never Done Unnecessarily. If a Upower handpiece is sent to us for repair and needs only a chuck, this will be all we repair and advise you that that Upower handpiece did not need a complete overhaul. If a Upower handpiece is tested and found to run and cut well, and does not require further repairs, we will not repair it arbitrarily, but rather advise you to check your unit or air pressure source or other give other advise.

Same Day Service For Your Upower Handpiece Repair. Most Upower handpiece repairs are done the same day that we receive them, and we ship your Upower handpiece repaired the following business day. Should there be any necessary delay, we will immediately notify you of the situation of your Upower handpiece repair.

Quality Parts In Our Upower Handpiece Repair. We use only the very best quality bearings and parts for W&H Adec handpiece repairs. We absolutely never use inferior quality or surplus bearings in any Upower handpiece repairs.